Baileigh press brake bp-5060nc

With its 6,000-pound steel frame, this hydraulic press brake makes crisp bends across its full 61” width. The stroke and back gauge are tied to encoders with DROs for precision.

Delivers up to 50 tons of pressure.

Maximum capacity of .118” thick sheet metal across the machine’s full width.

5 hp main motor requires 220-volt 3-phase power.

POWERFUL, EASY-TO-USE HYDRAULIC SYSTEM

Runs in 3 modes: jog mode for setup, manual mode for more control over descent and return, and automatic mode for full production.

2 encoder-controlled hydraulic cylinders move the top beam.

Digital readout (DRO) displays the position of the downward stroke, so you can fine-tune a bend and make it right every time.

It takes a just few seconds to change the top beam pressure and the top position of the stroke (for more or less travel).

You can set a timer for bend delay to hold the beam down at the bottom of the stroke, so the bend keeps its shape.

2 hand wheels let you adjust the position of the beam and back gauge for consistency across the entire width of the beam.

Foot pedal brings the stroke up and down, leaving your hands free to position the material.

Motorized back gauge rides on a solid ball screw trolley mechanism.

Back gauge encoder shows its position on its own DRO.

Parallel mechanism on the beam synchronizes the top and bottom die to deliver better quality bends across the entire width of the machine.

Download Brochure